Help with flow tower

[5axes]

Help with flow tower

[5axes]

That's a very good question ! To be honest I'm Not very satisfied of this test. In the Online version the difference between the pin Width and the female geometry is just 0.05mm : wo=w+0.05

For Cura that's not enough, but this value should be dependant of the Layer Height parameter, so on a theoretical point of view it's hard to use a fixed geometry to define what is the best flow parameter, whithout fixing a layer height value. What's why I think this test is not a good one.

At the present time, I'm using something like :

lay=0.2; // Layer Height
w=4; // Pin Width
wo=w+lay; // Housing Width

I should make some tests to find the best compromise. But as it was not in my top priority if you have time to work on this point so if you have times to work on it, your feedback on the issue would be greatly appreciated.

[mbeale0]

I'm pretty new to all the calibrating things for 3d printing so I may not be thinking of this right, and probably dont have much to offer, but could you measue the depth of pin instead? something that should be consistent no matter the layer height? or maybe that isnt as affected by changing the flow

[tkang2020]

Have you tried the Multi-Flow test part within the Cura Parts for Calibration extension? I tried that one and it gave me a better idea of how the first layer adhesion was affected by flow, as well as the top layers since it's about 4-5 layers tall per card. Gotta have a level bed to make sure it's not a factor, but they're very small and quick to print. Github Doc also has some decent examples of over/under extrusions in pics.