MinimOSD always shows "Update Charset" on power up, requires hard reset before use.

[GoogleCodeExporter]

MinimOSD always shows "Update Charset" on power up, requires hard reset before use.

[GoogleCodeExporter]

If there is no elegant all-in-one solution, an easy fix would be to release a 
normal firmware, and in addition, a No Update Charset (NUC) version, which 
would have the capability for Update Charset commented out.

Also, the more I think about this, what if we could set the Telemetry delay in 
the CGS to 20 or more seconds?  Currently it limits to 10.  The capability to 
set 20+ seconds there might resolve this issue completely.

Original comment by [email protected] on 12 Nov 2012 at 6:53

[GoogleCodeExporter]

OK, after further reading of the code and testing, I realized that LOWERING the 
TELEM_DELAY to be less than 5 seconds (0 to 4) will fix this problem, not 
raising the delay as I had originally thought.  I think this just needs to be 
documented somewhere on the MinimOSD page and this bug can be closed.  Thanks.

Original comment by [email protected] on 17 Nov 2012 at 8:50

[GoogleCodeExporter]

Hi Debaker! It was documented here:
http://code.google.com/p/arducam-osd/wiki/Troubleshooting

Thanks!

Original comment by [email protected] on 12 Jan 2013 at 12:03

• Changed state: Done
• Added labels: Type-Task
• Removed labels: Type-Defect

[GoogleCodeExporter]

I am having this issue UPDATE CHARSET
PX4 2.76 plane
OSD fw 2.0
I have tried various TELEM_DELAY as recommended (default was 0) at no avail.
Initially the two supply jumpers on the minimOSD was connected (supplying from 
12V).
I removed the solder jumpers and problem persists.

Would this not justify a OSD firmware fix?!
It is quite frustrating...
/ Tom

Original comment by [email protected] on 29 Nov 2013 at 6:14