chinese characters with clone

[GoogleCodeExporter]

chinese characters with clone

[GoogleCodeExporter]

Good luck with your clone! You'll probably need it.
Unfortunately, many of those clones out there have all the sort of hardware 
issues as well as no firmware, no bootloader or no charset loaded.

At first look it seems to be a wrong voltage on the Maxim 7456.
You need to check it or contact your vendor for a replacement.

Original comment by [email protected] on 7 Jan 2013 at 1:42

• Changed state: Invalid

[GoogleCodeExporter]

can i reprogramm it with usbasp ?? and how ?? thank you again 

Original comment by [email protected] on 7 Jan 2013 at 3:58

[GoogleCodeExporter]

No. You cant update charset through a SPI programmer.

Original comment by [email protected] on 12 Jan 2013 at 12:06

[GoogleCodeExporter]

SOLVED  - I had the same problem and thought I wasted my money on this clone.  
Try powering both sides of the MinimOSD board and then update the character 
set.  I connected my OSD to the PC via FTDI and then connected the transmitter 
and camera to the OSD. My transmitter supplied the 12v.  I guess you could just 
supply 12+ and ground to the IN connectors and have the same outcome.   

Original comment by [email protected] on 23 Jun 2013 at 11:42

[GoogleCodeExporter]

SOLVED agree with  #4 [email protected] :p work fine 2.2 version with 
Charset_Trug_Small.mcm (char) connect with 5v and 12v for cam load CT tOOls and 
update the character

Original comment by [email protected] on 22 Jun 2014 at 2:56