How to use Serial1 instead of NewSoftSerial

[GoogleCodeExporter]

How to use Serial1 instead of NewSoftSerial

[GoogleCodeExporter]

You're right we're going to fix it.

Original comment by [email protected] on 22 Aug 2012 at 9:48

[GoogleCodeExporter]

Can you guys tell me which arduino pins are currently being used in this 
library?

Original comment by [email protected] on 27 Aug 2012 at 2:14

[GoogleCodeExporter]

4,5 or 2,3 for NewSoftSerial, it depends on what version you are using (4,5 for 
the first, 2,3 the second one). 

Original comment by [email protected] on 27 Aug 2012 at 8:47

[GoogleCodeExporter]

Sorry about all these questions, but I'm kinda lost using this shield.
I've tried all these pins in UART multiplexer, but I'm receiving this all the 
time:
GSM Shield testing.
DB:NO RESP
DB:NO RESP
DB:NO RESP
ERROR: SIM900 doesn't answer. Check power and serial pins in GSM.cpp

status=IDLE

Any idea?

Original comment by [email protected] on 27 Aug 2012 at 7:24

[GoogleCodeExporter]

I suggest to you to use the OpenElectronics/Futurashop Shield, because this 
library is developed for that shield.
http://store.open-electronics.org/
Marco

Original comment by [email protected] on 31 Aug 2012 at 4:37

[GoogleCodeExporter]

I've had this problem too. I changed the pins of TX/RX to 2,3. then switched 
from UART to USART. then it worked fine. :)

Original comment by [email protected] on 13 Oct 2012 at 4:55

[GoogleCodeExporter]

Original comment by [email protected] on 11 Dec 2012 at 5:01

• Changed state: Done

[GoogleCodeExporter]

This issue section is not longer supported.
Please check the support page www.gsmlib.org 

Original comment by [email protected] on 6 Jul 2013 at 11:27

• Changed state: Fixed