Screen recording as video, audio on SharpAvi - Audio not recording

[bassill]

Screen recording as video, audio on SharpAvi - Audio not recording

[BranigansLaw]

I know this is old, but I'm stuck at the same place with this.

@Gopichandar, did you even get your solution working?

[BranigansLaw]

Just to follow up on this, I believe the issue is using the JPEG Motion format which might not allow embedding of audio. I tried switching to DivX format but SharpAVI kept throwing an exception I didn't have that codec (even though DivX is installed on my system).

In the end, I decided to switch to recording the sections separately and then recombining with ffmpeg.

If anyone found a way around this, let me know! I'd much rather stream into on file then saving and using ffmpeg to recombine.

[cytivrat]

I doing the same thing and I get part of the sound, but it is in extremely bad quality, too many silent pieces: like I'm saying 1-2-3-4-5-6, 1 can go properly, then start of the 2, then silence or some noise and then I get the end of three and no 4-5-6 at all.

[cytivrat]

As I found out, in my case adding new frame took 0.2-0.3 seconds, when I set frame rate to 10. So I was getting a new frame data longer than I tried to write it. After I optimized my code that creates a new frame, I was able to get clear sound inside recorded avi file