bad results

[bastibl]

bad results

[bastibl]

Maybe you can find something useful here:
https://www.wime-project.net/installation/

In addition to that, I would recommend to

• make sure that there are no Overruns (i.e., that the receiver can catch up with the same stream)
• check the constellation plot (it should give you a good idea if decoding works)
• try different LO offsets to tune the oscillator out of the band of interest
• make sure that frame detection works (i.e., that decoding is only triggered if a frame is sent)

[edapej]

Hello @bastibl Bastian,

I get this error while I'm trying to transmitt from TX to RX or even when I'm using the Transceiver:UHD Warning:
Unable to set the thread priority. Performance may be negatively affected.
Please see the general application notes in the manual for instructions.
EnvironmentError: OSError: error in pthread_setschedparam

I installed VOLK, checked the daughterbouard, changed the permission file /etc/security/limits.conf by adding at the end @group -rtprio 99 and still no good performance

Any help or ideas?

Thanks again,

[bastibl]

Did you actually check the above points?
If so, could you please describe more verbose what's going wrong?