Issue with masks not matching image after saving them

[simondsmason]

Issue with masks not matching image after saving them

[xconverge]

If it were me, I would hardcode the detect resolution to the resolution of the substream. Your back garden camera is using the substream so it should be "the smaller" image probably, and the mask should be made/updated once this is done. What is the resolution of your substream?

Maybe the auto-detecting of the resolution is not working well/deterministically with your stream source, not sure really

[xconverge]

Did you make the mask on the non-substream and then switch to using the substream? The mask needs to be created for the stream that will be used for detect. If you adjust resolution of this stream for any reason, the mask will need adjustment

[nwish]

I reported this a while ago and Nick said that they were going to make zone points relative to the camera view rather than hard coordinates in a later release. Until then, if you change the size of your detect feed, you'll want to comment out, or remove your existing zones.

[simondsmason]

I haven’t changed the config. But it gets weirder. I redid the masks and zones on the reduced image size. I restarted frigate and this time when I went into the mask and zone creator it now shows the full size image again. And the masks and zones are correct.

[NickM-27]

closing this as a duplicate of #6309 as that is what will fix it

[NickM-27]

@xconverge is correct, I would definitely recommend manually setting detect resolution