GPS connection for iC880A

[ch2i]

GPS connection for iC880A

[hallard]

HI @Octoate
Yes, sure it could be easy, would you mind give me reference or pointer on the header you need? The GPS board you want to put on
Thanks

[Octoate]

Well, I guess it would make sense to use a GPS sensor that is widely available, so I wouldn't recommend the one, I am using here (and it doesn't have a pin header anyway ;-)). Maybe the pin header for the NEO6MV2 would be nice like on this boards:

https://www.ebay.com/itm/GY-NEO6MV2-NEO-6M-GPS-Module-Board-with-Antenna-for-Arduino-Raspberry-Pi/142660988559?hash=item213741ee8f:g:vuIAAOSw61haaANE

or, because it has a good availability, the one of the Adafruit Ultimate GPS:

https://www.adafruit.com/product/746

What do you think?

[hallard]

I'm using this one on my RAK831 PI Zero Board Would it be okay for you ?

Another Idea would be using an USB One, unfortunately both same pinout execpt TX/RX reversed, that's a same, so USB Only
https://www.electrodragon.com/product/neo-6m-gps-module-r2/

But It's easy to wire this kind on board on existing shield, RX/RX/GND are available on FTDI connector, just need to get 3V3 and set PPS to a GPIO available (GPIO13 for example on Groove connector). Of course change GPIO to reflect this change if you want to use GPS with packet forwarder.