porting to esp-01

[csnol]

porting to esp-01

[csnol]

Hi, @alifilhan
You know, We need 4 GPIOs to OTA STM32

* 2 output GPIOs for STM32's BOOT0 and RESET. 
* 2 GPIOs as a  EVEN Serial port to communicate with STM32.

You can use ESP-01's GPIO-0 and GPIO-2 (10K pullup both) to control BOOT0 and RESET
RX and TX to communicate with STM32.

Yes, That's all.

[alifilhan]

Thanks for replying. That means I just need to change the PIN 4 and PIN 5 to PIN 0 and PIN 2 only? Or I need to make more changes inside the code? Thanks

…

On Sat, 18 Apr 2020, 11:48 a.m. csnol, ***@***.***> wrote: Hi, @alifilhan <https://github.com/alifilhan> You know, We need 4 GPIOs to OTA STM32 * 2 output GPIOs for STM32's BOOT0 and RESET. * 2 GPIOs as a EVEN Serial port to communicate with STM32. You can use ESP-01's GPIO-0 and GPIO-2 (10K pullup both) to control BOOT0 and RESET RX and TX to communicate with STM32. Yes, That's all. — You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub <#3 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AO3534NYTYG2VO6IMX5HWBTRNE5MVANCNFSM4MK2Y25Q> .

[csnol]

@alifilhan

Yes, no more code.
helpful information.
https://www.instructables.com/id/How-to-use-the-ESP8266-01-pins/

[alifilhan]

Thanks a lot. As I am done I am closing the issue

…

On Sun, 19 Apr 2020, 1:50 p.m. csnol, ***@***.***> wrote: @alifilhan <https://github.com/alifilhan> Yes, no more code. helpful information. https://www.instructables.com/id/How-to-use-the-ESP8266-01-pins/ <http://url> — You are receiving this because you were mentioned. Reply to this email directly, view it on GitHub <#3 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AO3534JXY3CVZ6R5XDC4XGTRNKUMBANCNFSM4MK2Y25Q> .