[BUG] PPS Errors with BSB-LAN Versions > 2.0.16

[malansk]

[BUG] PPS Errors with BSB-LAN Versions > 2.0.16

[fredlcore]

Since I no longer have access to a PPS controller, I would need serial monitor log files from all three versions, both when running in passive mode as well as in room unit mode. The logs need to begin when booting the Arduino and need to run for 1-2 minutes and during that time you should change the problematic parameters.

[malansk]

Yes, I was trying to get serial monitor log files from the Arduino Due but was not successfull. Later I found some reference posts that one the Due it‘s not possible to get the SerialMonitor output from the same port like the programming was done, so I will try to open the case and switch over the USB cable from native port to programming port to get some logfile. Would logfile from SD-Card also work ? I saw some options to enable logging of telegrams.

[fredlcore]

No, that is wrong information. Yes, the Due has two USB ports, but for BSB-LAN, both programming as well as serial output is via the programming port. And no, logging to SD card is not enough in case of troubleshooting as the logs do not cover both sending and receiving data.

[fredlcore]

I have had reports from PPS users using the most recent BSB-LAN version on a rather old (even for PPS) RVA36 controller. So I assume your situation is a bit more specific. With the said log files, I can nevertheless have a look, but without these, there's nothing I can do. So for the moment, I'm going to close this issue until there is further background information.