Ícaro Fernando Caetano Barroso's Projects
Repository to save my work with TI`s 2.4GHz pcb antenna to be used with Kicad
ADC reading raw and calibrated voltage
A generic firmware for communication from MCU to Nextion display
This is a code for ADC readings with timers and serial printing, a non blocking program, analogRead() and serial print at atmel(microchip) studio.
A basic program for nextion display usage w/ esp32 on esp-idf
Project for University laboratory
Ainda deve ser testado, codigo pwm, gera 1khz, 500hz e 250hz nas portas D7,D6,D5 respectivamente
Curvas de torque de um motor de rotor bobinado
A brief example of adc as a component implementation on ESP-IDF using CPP
A brief example of gpio component implementation on ESP-IDF with option to enable and disable both pullup and pulldown and also option to install ISR on input
This is an example of the basics of ESPNOW protocol, with a sender and a receiver... and some easter eggs hehe...
Config files for my GitHub profile.
Jogo de matematica trabalho facul
Projeto LEDA com Renesas S7G2 SK
A generic frequency PWM generator, a basic software that has the base to create a PWM with a high precision frequency application.
Description : This is an code that works on Renesas S7G2 SK Evaluation Board. It sends a string through SCI UART 0 each time you press one of the buttons, SW4 or SW5. The string is sent with the name of the pressed button "SW4" or "SW5". With TX short circuited to RX(using a jumper), it receives the string sent by the button's interrupt function, the it validates the information received and blinks the assigned led, LED GREEN for SW4 and LED RED for SW5
A program that uses registers to program a STM32F1, Blue pill, so that I can time a HIGH signal very accurately.
STM32 BLUEPILL firmware developed with STM32 Cube IDE
This is a repository for me to develop a stm32cube ide project to work with rak3172 LORA module and CAN bus, also reading onboard temperature
Just a source code for future ADC,DAC,Serial Nextion applications.