EMI shielding

[jonnew]

EMI shielding

[jonnew]

Also to note: keeping cables short and low inductance is the best way to reduce EMI and improve the device's performance. I actually mount my LED right to the back of the device using a copper clad PC board with a couple banana plugs screwed into it.

[jonnew]

Probably not in most situations. This is especially true if you are using a digital acquisition system, e.g. with Intan headstages and the cyclops is very far away from the analog portion of the circuit.

[jonnew]

@jsiegle, sorry, I deleted your last comment when I clicked on it, can you repost?

[jsiegle]

Just wanted to add that the power connector for the Arduino touches the bottom of the enclosure, so anyone using a conductive coating should be careful not to spray it there.

[jonnew]

Ah, yes. I need to add this to the manual. When installing the arduino, I always remove the power jack using a hot air gun to prevent this.