Control Bed Fans

[jontek2]

Control Bed Fans

[jontek2]

Hey!

Start by adding your bed fans as a fan, something like:

[output_pin bed_fans] pin: XXX value: 0 shutdown_value: 0

Where XXX is your PIN on your controller.

Then you can add the following to your print_start macro to active the fans:

SET_PIN PIN=bed_fans VALUE=1

A good place to add that logic would be the Nevermore activates, it would look something like this:

SET_PIN PIN=nevermore VALUE=1                      # Turns on the nevermore
SET_PIN PIN=bed_fans VALUE=1                       # Turns on the bed fans

Don't forget to turn off the bed fans in your print_end macro with SET_PIN PIN=bed_fans VALUE=0

[airbornetrooper82573]

Thank you! I will add that to my config

[jontek2]

NP! I'll go ahead and close this issue.

Good luck and happy printing!