using cc2530 with UART and arduino

[guitar9]

using cc2530 with UART and arduino

[SAGARP169]

@guitar9 Did you get any way out of it

[guitar9]

@SAGARP169 no. But I am interested to start developing. I dont know really where to start. Do you have a starting point?

[SAGARP169]

I have almost reached, but cannot communicate the model with micro controller, the only thing i can do is send and receive data through the third party software, i cannot read/send this data through any com port (i.e arduino ide serial monitor).

in the above image you can see how i send command from co-ordinator to router and vice versa.

What i have used is cc2530+cc2592 module from EBYTE Model-"E18-MS1PA1-PCB"
No firmware need to upload initially it comes with the ready firmware and software can be downloaded from there website for relative product
software which i used was "Zigbee Setting v1.2"

[SAGARP169]

I am very bad in programming, so can't even understand program properly, if you get any related info please share
Email:
Thank You!!

[wassfila]

If you'd like to port zigbee2mqtt to arduino, that's a lots of code.
You should first go to the lower layers : cc-znp is the one using the serial port. Or you could start a new implementation by checking the TI documentation, the UART protocol for the znp is documented on "Z-Stack Monitor and Test API".

[stale]

This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.