Error when running ./bruteforce and ./data_partition

[GoogleCodeExporter]

Error when running ./bruteforce and ./data_partition

[GoogleCodeExporter]

I just tried this again and didnt experience the same errors.

Interestingly when I run ./bruteforce it will not automatically mount the 
/dev/disk0s2 partition automatically. I get the following error:

-sh-4.0# ./bruteforce                
Trying to mount data partition
FAIL: mount /dev/disk0s2
FAILed to load keybag

If I then manually mount the partitions everything works ok.

Original comment by [email protected] on 27 May 2011 at 7:51

[GoogleCodeExporter]

Hello,
Indeed the mounting code fails when the filesystem was not unmounted cleanly. I 
just pushed some code to correct the issue by running fsck on the data 
partition. 
For the "CoreFoundation: failed to dynamically link symbol" errors, these do 
not seem to prevent the programs from running correctly.

Thanks for your feedback

Original comment by [email protected] on 27 May 2011 at 11:49

• Changed state: Started

[GoogleCodeExporter]

Original comment by [email protected] on 17 Jul 2011 at 2:57

• Changed state: Fixed