Incorrect Battery % vs Battery Voltage

[qwerty84532]

Incorrect Battery % vs Battery Voltage

[bencrundwell]

It looks to me like you might have a bad cell sat at 3.71v. Try a balance charge by leaving it on charge overnight and see if the cells are more similar and the % more accurate? Its possible the BMS uses the lowest cell voltage for safety

[qwerty84532]

Ben, Yes, that cell is playing up. I did do the overnight balance and all the cells were pretty balanced at 4.2V if I remember right. But during charging, that cell would always read a little higher than the others until it eventually settled. The battery percentage in the OW app would read closely reflect what the OWIE said the battery voltage was.  Once you start riding there would be a difference, the App showing lower battery percentage.  If you stopped and waited a few minutes, the battery percentage in the OW app would go back up to reflect the actual battery Voltage based  percentage. Once I updated to to 1.4.3, the first thing I noticed was that charging the battery would 'get stuck' around 70%.  I thought that because the later updates changed the voltage lookup tables and would show fully charged at 4.14V (I think) and the potentially bad cell with the higher voltage during charging would trigger the charging to stop. When I noticed the discrepancy in OWIE battery voltage vs the shown charge% in OWIE and app, I downgraded to 1.4.2 and 1.4.0 with the same results. Once I downgraded to 1.0.0, the OWIE and OW app reported battery % reflected the correct percentage based on the battery voltage. Thanks for your time and feedback. Mick On Wednesday, February 7, 2024 at 03:42:15 PM MST, Ben Crundwell ***@***.***> wrote: It looks to me like you might have a bad cell sat at 3.71v. Try a balance charge by leaving it on charge overnight and see if the cells are more similar and the % more accurate? Its possible the BMS uses the lowest cell voltage for safety — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: ***@***.***>

[bencrundwell]

Hmmm, I'm not sure what more I can offer I'm afraid. I'm still relatively new to the project myself and am in a similar place to where you were initially. The App % is going down too fast and then recovering when I stop. My logs have lots of charging stops in them!

Today I've pulled the latest code as it looks like the main developer was working on a coulomb counter approach and more dynamic battery capacity detection, but haven't been out for a ride to test it yet. Annoyingly I'm still on the stock battery and use OWIE for other reasons, so I actually do just want the battery to be passed across to the controller and not modified really