Not getting response for config_get or rule_get

[ndejong]

Not getting response for config_get or rule_get

[ndejong]

Thanks for the report, could you provide:- - pfsense version - fauxapi version - output from debug, have a read of the docs on this if needed On 17 Jul 2018, at 13:55, mugdhaadhav <[email protected]> wrote: Hi, My API call for system_stats, config_reload, etc are working fine but it fails for config_get and rule_get. In the logs I can see the request reaches pfsense and also it is a valid request, but after about a min it says authentication failed 401 Unauthorized because of timeout. This is my request: curl -k -s -X GET -H "fauxapi-auth: ${fauxapi_auth}" http://${fauxapi_host}/fauxapi/v1/?action=rule_get — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#27>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AAM2KgGb5D9Sc9CFsCxfCf7Cy3GL17GQks5uHXxSgaJpZM4VSOar> .

[mugdha-adhav]

Hi,
Pfsense Version: 2.4.3
FauxAPI Version: 1.3_1

Attaching the output for clog /var/log/system.log | grep fauxapi

It's taking too long for sending response so its failing I suppose.
Thanks for quick reply.

[ndejong]

Please add a __debug=true parameter to your curl request, this will provide a lot more detail into what's going on

For example, based on your original-post, the curl request you might send would look like this:-

curl -k -s -X GET -H "fauxapi-auth: ${fauxapi_auth}" http://${fauxapi_host}/fauxapi/v1/?action=rule_get&__debug=true

For reference, the debug documentation is found here:-

• https://github.com/ndejong/pfsense_fauxapi#debugging

[mugdha-adhav]

Hi,
I tried this earlier as well, but __debug=true parameter doesn't work. The request is sent but it waits till timestamp goes out of bounds and then sends, authentication error. Getting the same error as above on all requests(including the ones working before) after using __debug=true.

[ndejong]

Please check that system time on your pfSense host and the host you are sending curl requests from are in sync - what you are describing sounds very much like the auth token is failing because the timestamps are not within 60s of one another - N On 19 Jul 2018, at 18:08, mugdhaadhav <[email protected]> wrote: Hi, I tried this earlier as well, but __debug=true parameter doesn't work. The request is sent but it waits till timestamp goes out of bounds and then sends, authentication error. Getting the same error as above on all requests(including the ones working before) after using __debug=true. — You are receiving this because you commented. Reply to this email directly, view it on GitHub <#27 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AAM2KpQqFlY6rYB75gfHTnQhw_iBXbSLks5uIFqFgaJpZM4VSOar> .

[mugdha-adhav]

Hi,
Thanks for you help and quick response. I figured out the issue. The request was failing due to the network proxy.