Raspberry pi keeps getting messages invalid address

[nrf24]

Raspberry pi keeps getting messages invalid address

[zarya]

btw this works without problems in the code from https://github.com/zarya/NrfPiNode/ but that RF24 and RF24Network libs are older.

[zarya]

Startup of the current RF24Network lib looks like this:
SPI device = /dev/spidev0.0
SPI speed = 8000000
CE GPIO = 25
STATUS = 0x0e RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=7 TX_FULL=0
RX_ADDR_P0-1 = 0xf0f0f0f03c 0xf0f0f0f05a
RX_ADDR_P2-5 = 0x69 0x96 0xa5 0xc3
TX_ADDR = 0xf0f0f0d23c
RX_PW_P0-6 = 0x20 0x20 0x20 0x20 0x20 0x20
EN_AA = 0x3f
EN_RXADDR = 0x3f
RF_CH = 0x50
RF_SETUP = 0x07
CONFIG = 0x0f
DYNPD/FEATURE = 0x00 0x00
Data Rate = 1MBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_MAX

[TMRh20]

Well, this is kind of an odd one. I would assume some sort of wiring/config issue, just because the pipe0 reading address shows as 0x0000000000, but not sure.

The is_valid_address code is still the same, so I assume it is either actually receiving an invalid address, or just getting garbage data due to a config issue.

Have you tested the new libs with an example sketch like the RF24 gettingstarted and/or RF24Network helloworld_tx / helloworld_rx ?

[zarya]

same if i run a semi unmodified version of rx-test (only thing changed it the RF24 radio() line and the includes of RF24.h and RF24Network.h
./rx-test
================ SPI Configuration ================
CSN Pin = CE0 (PI Hardware Driven)
CE Pin = Custom GPIO25
Clock Speed = 4 Mhz
================ NRF Configuration ================
STATUS = 0x0e RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=7 TX_FULL=0
RX_ADDR_P0-1 = 0x0000000000 0xf0f0f0f05a
RX_ADDR_P2-5 = 0x69 0x96 0xa5 0xc3
TX_ADDR = 0xf0f0f0e13c
RX_PW_P0-6 = 0x20 0x20 0x20 0x20 0x20 0x20
EN_AA = 0x3f
EN_RXADDR = 0x3f
RF_CH = 0x50
RF_SETUP = 0x07
CONFIG = 0x0f
DYNPD/FEATURE = 0x00 0x00
Data Rate = 1MBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_MAX

[zarya]

Found out wat was wrong, if you leave a old lib in place it does not work ;)