Sensor Missing

[phrz]

Sensor Missing

[raliseda]

I have the same issue, when I change display time to remaining time, it works but since the timer uses seconds, the display wont fit.
Have you manage to resolve this?
thanks

[charbottle]

Sorry, found the issue. The instructions stated to change the washer to whatever LG named them, which in my case was front_load_washer. So when I went thru the configuration.yaml, I renamed them all. But it appears I did not need to rename both door_lock & remain_time. Here is my updated configuration.yaml

sensor:
- platform: template
  sensors:
    washer_door_lock:
      friendly_name: "Washer Door Lock"
      value_template: "{{ state_attr('sensor.front_load_washer','door_lock') }}"

    washer_time_display:
      friendly_name: "Washer Time Display"
      value_template: >
        {% if is_state('sensor.front_load_washer_run_state', '-') %}
        {% elif is_state('sensor.front_load_washer_run_state', 'Standby') %}
          -:--
        {% else %}
          {{ as_timestamp(strptime(state_attr('sensor.front_load_washer', 'remain_time'), '%H:%M:%S')) | timestamp_custom('%-H:%M') }}
        {% endif %}
    
    dryer_time_display:
      friendly_name: "Dryer Time Display"
      value_template: >
          {% if is_state('sensor.dryer_run_state', '-') %}
          {% elif is_state('sensor.dryer_run_state', 'Standby') %}
            -:--
          {% else %}
            {{ as_timestamp(strptime(state_attr('sensor.dryer', 'remain_time'), '%H:%M:%S')) | timestamp_custom('%-H:%M') }}
          {% endif %}

    blank:
      friendly_name: "Blank Sensor"
      value_template: ""

[charbottle]

I fixed the seconds issue that was found in Issue #11 using their suggestion. But it's also shown in the above code.