Unable to use debugprobe

[emanuellopes]

Unable to use debugprobe

[kamuycikap9821]

Hello.

I believe the OpenOCD you have created is complete.
I believe that the error is a correct result.

I would expect that if you set up PicoProbe, connect it to your Macbook, and then start it, you would not get the error.

A blog I wrote might be helpful.
https://kamuycikap.hatenablog.com/entry/2024/03/02/201039
*It is in Japanese, but I think you can read the command prompt.

Good luck.

[emanuellopes]

Some days ago I was able to debug using debugprobe, the first time doesn't work and I notice the cables are not connected correctly.

After that the debugging started and I was able to get data in serial console.

After that I don't know what happened but the debugprobe didn't work anymore.

I have read your post and I did everything you have did.

Should I connect debugprobe after all connections are done in pico? Today I will test it again.

[kamuycikap9821]

Hello.

Yes, I am looking for a new job.
Run the command with the PC, PicoProbe and target pico connected.

I also compiled and installed "debugprobe" but it did not work correctly.
I used picoprobe.uf2 which is released on GitHub instead of debugprobe.
https://github.com/raspberrypi/debugprobe/releases

One thing I am a little concerned about is that the terminal where OpenOCD is running is different from the terminal where GDB is running.

After running OpenOCD first, I leave that behind and open a new terminal to start GDB.

If your computer, PicoProbe, and target Pico are all connected, it should work.