DWG Review: Create Flange Panel

[sliptonic]

DWG Review: Create Flange Panel

[shaise]

I'm not sure the term Flange is good for that. Usually the flange is on the lip of the part and the last bend created. I do not know if Bend is the correct one, but Flange might be misleading

[maxwxyz]

So maybe #325 Extend could be Extend flange or add flange and this here should be just Fold or Bend?

[shaise]

I do not know if extend is a flange as well. Extend is used to make the walls wider to reduce gaps.
As far as I understand this is a standard box:

and this is a box with a flange:

So the walls are bends, and flange the protruding lip. Both operations uses "Bends" but only the last one is considered as a "flange". We need an expert machinist remark on it.