shm-dmitry Goto Github PK

3dprinter_control

Smart house integration with 3D printer. WIFI and camera interface to your printer. Auto power down when printer finished.

air-detector

Air status sensor with hass integration and fan control

atmega_esp32_logger

This firmware allows to read stdout from ATMega microcontroller without JTAG interface

auto_close_window

This IOT project allows you to open and close your window from any smart house. For example - you can setup rules like a "If night and noise greater then expected -> close window" and "Noise reduced -> open window"

climate_control_sensor

Firmware for a climate control device/sensor, based on ESP32 DevKit board

crate-driver

Metabase driver for CrateDB. Community-supported.

ender3v2

This is optimized firmware for Ender3 V2/S1 3D printers.

hass_pik_intercom

Базовая поддержка домофона ПИК в HomeAssistant

ir_decoder

IR Decoder for climate control sensor.

pantry_signal_system

This project contains schematics and firmware for controlling patry, garage, etc. Its including flooding sensor, auto air dryer and signal system. It connected to smart house using LoRa channel

superslicer

G-code generator for 3D printers (Prusa, Voron, Creality, etc.)

supply

train_barrier

xray-detector