preset mode being set on wrong entity

[swingerman]

preset mode being set on wrong entity

[swingerman]

I detected an issue that the supported features are detected when you change HVAC modes. supported_features sets if the thermostat supports preset mode or not.
It's bugg. Working on the fix.
Will be out in 1-2 days

[swingerman]

Wait with this @mbrevda.
I am currently working on this.

I plan to release a beta today or tomorrow.

[mbrevda]

bump - anything I can do to move this forward?

[swingerman]

• preset_modes are the available preset modes - based on your configuration.
• preset_mode is the currently selected preset mode

[mbrevda]

I see
But why are some entites missing the preset_modes altogether?

[paulius2k]

@mbrevda have you defined any of the preset_modes in the configuration of your "boys_room" thermostat? Like away: or home:? If you haven't, then they will not be available for you.

[mbrevda]

Yes, I have - see yaml above

[paulius2k]

Sorry, my bad for missing it.

Try fixing your temps in away preset:
target_temp_low: 50 0
target_temp_high: 0 50

This will fix your problem.

[mbrevda]

This will fix your problem.

I don't think it did?

[paulius2k]

I tried it in my setup, and it works. Then it could be some other parameter which is influencing this in your setup.:

P.S. sorry to ask, but you did remember to reload your yaml config after changes? :)

[mbrevda]

did remember to reload your yaml config after changes

Yes, I did, and also reloaded home assistant when I didn't see the changes.

I tried it in my setup, and it works

I'm sure. Where do I go from here?

[jkrasinger]

@mbrevda : As i can see in your yaml definition above, you must also specify the "temperature", not only "target_temp_low" and "target_temp_high", then it will work.

[mbrevda]

even in heat_cool mode? What would temperature be in that case?

[swingerman]

v0.9.5-beta.1 is out

[mbrevda]

v0.9.5-beta.1 is out

Thank you - it does not seem to have resolved the issue, though:

[swingerman]

The only potential problem that I can see at this point is that the target_temp_high is higher than the max_temp

But I will take your config tomorrow and see. The supported_features: 129 seems to indicate that preset modes are not supported.

[swingerman]

Please check v0.9.5-beta.3

I managed to reproduce and fix the issue. I also added a test to cover it.

[mbrevda]

I appreciate the efforts, but afraid the presets still aren't registering...

[swingerman]

Can you confirm that you use the same configuration that you used earlier?

[mbrevda]

Exactly the same

[swingerman]

Mirroring your confirmation, I can't reproduce the issue.
There may be some old state that was misconfigured and gets applied back.

Could you create a duplicate of boys room config with a different name and see?