Unable to add PFSense

[paulharman]

Unable to add PFSense

[crschnick]

This is probably the same problem as in #89, but it was only fixed for opnsense as I only had access to that. I should be able to adapt the fix to support pfsense as well

[crschnick]

Can you try whether the latest PTB version works for you: https://github.com/xpipe-io/xpipe-ptb ? That would save me a lot of time setting up pfsense just to test this.

[crschnick]

This should be fixed in the latest release

[paulharman]

Sorry I didn't see your message before. Unfortunately it doesn't seem to be working, same issue on 1.7.13

Shell did not start up in time as we did not receive any response. In case the shell is just slow, you can try increasing the timeout value in the settings.

Netgate pfSense Plus - Serial: xxxx - Netgate Device ID: xxxxx

*** Welcome to Netgate pfSense Plus 23.01-RELEASE (amd64) on pfSense ***

WAN (wan) -> igb1 -> v4/DHCP4: x.x.x.x/20
LAN (lan) -> igb0 -> v4: 192.168.0.1/24
OPT1 (opt1) -> em0 ->

0. Logout (SSH only) 9) pfTop
1. Assign Interfaces 10) Filter Logs
2. Set interface(s) IP address 11) Restart webConfigurator
3. Reset webConfigurator password 12) PHP shell + Netgate pfSense Plus tools
4. Reset to factory defaults 13) Update from console
5. Reboot system 14) Disable Secure Shell (sshd)
6. Halt system 15) Restore recent configuration
7. Ping host 16) Restart PHP-FPM
8. Shell

[crschnick]

Can you start xpipe in debug mode and send me the output when it connects somehow? You can find that under Settings -> Troubleshoot

[paulharman]

No problem. Where is the output saved please?

[crschnick]

It is only printed in the terminal as it might contain sensitive information, so it's not stored anywhere.

[paulharman]

Sorry what terminal? I am on windows

[crschnick]

If you successfully launch it in debug mode, there should be a terminal window opening up, e.g. cmd or windows terminal depending on what you use.