CR-10S Pro issues

[z-bolt]

CR-10S Pro issues

[EvilGremlin]

1. Could be anything but probably firmware issue. What "slow" command?
2. Not related to octoscreen & octoprint at all. How do you power your PRi? From printer's PSU? Don't do that.
3. Does octoscreen even work with printer sd card? @alexkv I think not. Or if it does, you have SD support disabled in octoscreen.

[corso1]

1. In retract/feed menu you have options slow/fast, Im using Marlin 2.0.
2. I have raspberry power suply, when I use home command it works.
3. Maybe its dumb question but how to upload gcode file if I use independently octoscreen on raspberry without octoprint on pc.
4. Server doesn’t respond, I dont know how to access octoprint.

[EvilGremlin]

1. Clarified, looks like improper value then (or too fast for your stepper driver)
2. This shouldn't happen at all. If your board powered from PRi USB, remove that connection (remove fuse, cut wire/trace, whatever there is). Or maybe your PSU is not enough to run PRi with display.
3. Through webUI or from slicer.
4. Connect with SSH/telnet, then see what's wrong with webserver.
   Anyway, at least describe your installation process (start from writing armbian image to SD). Else all you'll have is futile random guesses.

[alexkv]

Third issue, I dont see anything in print directory on octoscreen, sd card is pluged in printer.
OctoScreen doen't work with printer's SD cards.

[JeffB42]

@corso1 I know this is an old bug. If you are still using OctoScreen, is this an issue? If it is, please update to 2.7.0, as it fixes a lot of bugs since 2.5.

[JeffB42]

Closed due to lack of response.