zzcc289/cornehole-case

A case for corne

Cornehole-case

Models in this repo are made for ZMK corne with nice!nano and are only roughly tested to fit specific parts listed below.

A case made for corne(crkbd), with holes.

Inspired by KBDfans Holy60.

Parts:

3D Printing:

Tree support recommended for the case.

Hardware:

Part	Count	Note
M2 x 10 Screws	10	For case assembly
M2 Hex Nuts	10	For case assembly
M2 x 4 Screws	4	For controller cover
M2 x 8 screws	4	For controller cover
M2 x 8 female to female standoffs	4	For controller cover
6mm x 2mm flat top round bumpon	10	Feet

Notes:

*There is no cutout for TRS/TRRS connector thus will need further modification to adapt for wired corne. The USB cutout also needs modification to fit the most recent corne v4 PCB with on board MCU.

*Clearance on the bottom between the case and the PCB is only 1.7mm, thus SLS printed metal case could have shorting problems.

*To use a normal 1.5mm/1.6mm corne plate instead of the 4.5mm 3D printed plate included in this repo, standoffs on the case need to be raised by 1.7mm and M2x10 screws need to be replaced by M2x12 screws.

*The M2 nuts are meant to be embedded into the printed plate as shown below, by using a soldering iron with a pointy tip at 250C.