adur1990/homeatmo

Simple ESP32 based BMP680 indoor air quality sensor.

homeatmo's Issues

Verify values

Use some off-the-shelf devices to verify the values produced by HomeAtmo

Set hostname for easier access

Currently, I have to use the IP to access the webpage. Using a hostname could make things easier.

Moving Average for IAQ

Sometimes, the IAQ shows short peaks over 50. we should use a moving average to flatten short peaks.

Colored graphs

Show good/bad/ugly ranges for the values in the corresponding graphs (e.g., the IAQ should be red above 100)

Add option to get only the values without graphs

For some cases, only the values without the graphs are intereseting (e.g. using iOS shortcuts to show the current temperatur in the widges view)

Once a day not working

The idea behind the notifications was to notify me if the IAQ is bad and then wait 24 hours. This is not working. I‘m notified once an hour.

Reduce sample rate

Currently, the sensor is pulled as fast as possible. But this is unnecessary and consumes a lot of power. This should be reduced to something like every 5 minutes.