anish-natekar/picow_copter

Affordable micro sub 100g coreless motor quadcopter made using Raspberry Pi pico W and controlled via an APP through WiFi.

picow_copter's Issues

Question : is there acro mode or only angle mode .

Is there acro mode or only angle mode ? Is there plan fo develop acro mode

flyback diode

In your present circuit design, what function does zener diode serve when attached to gate of mosfet? When mosfet is turned off where does back emf from motor go? I think back emf would fry mosfet in long run. A flyback 5819 schottky diode at drain of mosfet blocking from vcc seems fine for the purpose.

Code compiled but no ap hotspot created

I successfully compiled the code on a pico w . I wired only the accelerometer . I do not get any error on the serial but no hotspot is created . Do i need to wire everything to be able get the hotspot ?

Update PCB to support XS connector for AIO FPV camera.

The PCB for the quadcopter was not designed to support a FPV camera but the Lipo battery can potentially have enough current to power a small 25mW FPV camera. The type of connector on the FPV camera is a female XS JST connector.
The PCB should have through holes for male XS JST connector to power the camera via the Lipo battery.