bdc0/businesscard

Brian D Carlton PCB business card

businesscard's Issues

KiCAD footprints for custom parts are not included

Specifically the two BGA ones.

Label QFN-16 pin pitches

Since there are two variants. Other parts show that.

Make back-side picture not show parts installed

Since the card will (always?) made without them.

Remove Open Hardware logo

Incompatible with NC

Explain fabrication issues

1. Which files are which. Especially files that aren't used for fabrication was an issue fab house asked about.
2. There aren't any interconnection in the copper between parts. Fab house asked about this.

Street name has typo

Bernado should be Bernardo.

Local fiducials on BGAs would be nice. And a third one on board would be nice.

Might not be needed in real world since a small board.

Issue to capture various possible improvements

• Add rotated 90 versions of smaller discrete parts?
• More common BGA than 49. What would that be?
• Show 1.0 mm BGA. Perhaps a partial one.
• Add 01005 part.
• [] Add 0.5 mm BGA. Some small ~9 pin one.

Could show multiple instances of the smaller RC parts.

Not a bug, an improvement.

QR code should ideally be inverted

It is white on green. Since QR codes are typically black on white, this means some QR code scanners can't read it. Many do, so not critical. If white background causes a problem with not having enough border or runs into the text, don't change.

Add direct link to this project in the card itself

This will be significant when other people use it. Plus since it is open source, should have that link directly.