blackspherefollower/nogasmchart

A Nogasm session recording tool

Nogasm Chart

A session recorder tool for use with the nogasm or protogasm

Features

• Records the output from a Nogasm/Protogasm
• Routes vibration intensity to Vibrators and/or Rotating devices to Intiface
• Recorded sessions can be reloaded

Roadmap

• Reloaded sessions should be replayable
• Output should support Linear actuator devices
• Edging algorithms should be implementable and selectable in software
• More input devices should be supported

nogasmchart's Issues

Feature: Make Embedded Buttplug.io work

I was being lazy, and skipped over implementing embedded Buttplug.io support.

Feature: Add ouput support

We graph input, but we should be able to pass that through to an output system.
This way well require an intermediary analysis/interpreter layer.

Feature: Alternative analysers

Right now, there's a very primitive nogasm motor speed to Buttplug.io VibrateCmd/RotateCmd forwarding class: this could be easily replaced by alternative algorithms, maybe looking for contraction patterns instead of using the average pressure.

Feature: Replay session

We should be able to replay a recorded session.
This will make more sense when we have pluggable analysers and outputs.

Feature: Add support for LinearCmd

It'd be nice if we had a way to make linear devices oscillate based on intensity.

Feature: Add support for input from Buttplug.io devices

Depends on Buttplug.io adding sensor subscription support first

Feature: Support Bullfrog Input

Add support for alternative nogasm serial output

Speed max is 255

knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.95 ,1274 ,1114 ,5.46
knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.84 ,1274 ,1114 ,5.40
knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.73 ,1274 ,1114 ,5.35
knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.63 ,1274 ,1114 ,5.30
knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.52 ,1274 ,1114 ,5.24
knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.42 ,1275 ,1114 ,5.19
knob, pLimit, speed, pressure, avgPressure, arousal
0 ,600 ,-45.31 ,1276 ,1114 ,5.14

Feature: Add support for input from Olimex EMG sheild

https://www.olimex.com/Products/Duino/Shields/SHIELD-EKG-EMG/open-source-hardware

Feature: Load session recordings

We record sessions now, but have no way to load them.

Can't read the COM4 Port

Well, it starts up now, but when I hit the start button, it says it can't read the COM4 port (which is where it's plugged into).

Won't start

I am on Windows 10 home and I don't have a device plugged in. When I run the program, it attempts to load, but fails. Do I need a device plugged in before starting? If so, a suggestion would be to load up, but put on the screen that a device needs to be plugged in first.