boudreau/anycubic-predator-klipper-configuration

A working configuration and klipper binary for use with the Anycubic Predator

Anycubic-Predator-Klipper-Configuration

A working configuration and klipper binary for use with the Anycubic Predator and its original TriGorilla-Pro control board

Setup

• Firstly you will need to flash the klipper firmware to the trigorilla board. This can be done by following the instructions on this page; using the provided klipper.bin file as the source.
• After uploading the board should be able to connect to the klippy host software (do note that the screen has not been configured, so it will remain black).
• Some reasonable delta parameters have been prepared for a default Predator, but you will now need to perform calibration.

Calibration

• Start by performing a probe calibration
• Then you must run basic delta calibration
• After performing basic delta calibration you can continue down the page to advanced calibration, the settings I used were a scale factor of 1.6, and print speed of 40mm/s