clubncaldes/svlocoio

Arduino configurable 16 I/O Loconet Module (GCA50)

svlocoio's Issues

Input with sensor address 1 is ignored

I've configured the GCA50an for 16 inputs, but the input which is connected to sensor address 1 is ignored.
I believe it is because of the following line:

--- SVLocoIO-old.ino	2020-12-29 21:13:46.997911309 +0100
+++ SVLocoIO-new.ino	2020-12-29 21:15:04.710904824 +0100
@@ -207,7 +207,7 @@
   // Check inputs to inform 
   for (n=0; n<16; n++)
   {
-    if (!bitRead(svtable.svt.pincfg[n].cnfg,7) && myAddr[n]>1)   //Setup as an Input greater than 1
+    if (!bitRead(svtable.svt.pincfg[n].cnfg,7) && myAddr[n]>=1)   //Setup as an Input greater than 1
     {
       //Check if state changed 
       currentState=digitalRead(pinMap[n]);

Can you verify?
Thanks!

Regards, Charles

Addresses over 128 not working

hello dani

i am facing a other problem. in the SVLocoIO sketch if i select output and address 128 its work. but when i go to address 129 no response. nothing happen. i see that the uno get the message. led is flashing. when change the output to input i have already test until address 496 and i get a response on my ecos. if i test the sketch LNCVSoundOutputV6 i have tested until address 400 and its work.

regards ronald