comicsans/anycubiy-i3--firmware

Custom Marlin configuration for Anycubic i3+

ANYCUBIC PRUSA I3 XL

This repository adds custom configurations for the Anycubic i3+ (also known as Anycubic i3 XL or Anycubic i3 Ultrabase) of the Marlin Firmware.

This printer is based on the Prusa i3 design and comes with a heat bed (the Anycubic Ultrabase) and an MK8 extruder, controlled by a RAMPS 1.3 board.

Please note that the Anycubic i3 Mega needs a different firmware (see here).

You can find the original fork (based on Marlin 1.1.0-pre8) in the ANYCUBIC_PRUSA_I3_XL folder. This version came most likely preinstalled on your printer.

Version information

• Versions < 1.1.5 have the same configuration as the original firmware but lower temperature settings
• 1.1.5 enables manual bed leveling via menu option
• 1.1.6 also introduces baby stepping for z axis
• 1.1.9 uses S-Curve Acceleration and Continue after Power-Loss options

Precompiled firmwares (without bootloader) in hex format are in the corresponding sub folders. You could use the OctoPrint FirmwareUpdater Plugin to easily flash them.

Unsuitable modification may damage the machine, so please check the configuration before using these firmwares.

To copy them onto your printer, SSH into your Pi and run:

sudo apt-get update
sudo apt-get install avrdude
exit

Then use these settings: