dskw/anetb8

Custom rebuild of the Anet A8 using 2020 extrusions

Rebuild of the Anet A8 with 2020 extrusions

Extrusions

• 1x 140mm
• 1x 220mm
• 2x 440mm
• 2x 400mm
• 4x 420mm

Hardware

• Geetech GT2560 https://www.geeetech.com/wiki/index.php/GT2560
• Buwei 3.3V 1 Channel Relais
• 12V 30A PSU (removed the top plate that holds the fan)
• Noctua NF-A6x25 (60mm)
• RepRapDiscount Full Graphic Smart Controller
• Raspberry Pi 3 B
• deleyCON 1x CAT6a MINI Keystone Jack Modul
• selfmade short 90° usb cables (Pi -> MCU, Pi -> USB Backport)
• selfmade short 90° LAN cable (Pi -> deleyCON)
• 10x15mm drag chain 1 meter
• E3D V6 Clone
• BMG dual gear extruder

All parts are printed in ABS with 5 top/bottom layers and 4 perimeters for maximum stability. (Voron settings)

Additional STLs:

• Printhead: https://www.thingiverse.com/thing:3453289
• Fanduct: https://www.thingiverse.com/thing:2121279 (Mistral_V2.1_Leo_N)

Printer

Electronis

anetb8's Issues

wrong pin mapping

pin list in pin_mapping.txt is correct, but mapped to the wrong alias pins. Check against https://github.com/Klipper3d/klipper/blob/master/config/sample-aliases.cfg