e-dreyer/creality-cr6se-klipper-config

Personal implementation and config for my Creality CR6-SE Klipper, Moonraker and Mainsail setup

creality-cr6se-klipper-config's Issues

Calbration Files

Currnelty all gcode files are excluded due to the specific directoy of gcodes. It would be great if a set of standard calibration files is available for tests at all times.

Color Change

Currently, the M600 command leaves a lot to be desired. It simply paudes the print, a manual change is made, and the print is resumed.

It is required for the user to extrude more filament by hand to ckealr the nozzle. This had led to many problems.

Ideally, an M600 or COLOT_CHANGE macro is required to:

1. Save the state of the print
2. Park the hotend safely.
3. Retract the current filament.
4. User inserts new filament
5. New fillament is purgered
6. The print state is loaded again.
7. The print is resusmed

Current architecture needs restructuring

Currently the system communicates the the Raspberry Pi via a Mosquitto MQTT server, which I would like to replace. this can be achieved with an RP2040 running as a secondary MCU and then all connected hardware such as the relayes, dimmers, fans and lights will word through it.

Requirement for multiple slicer profiles

I am currently in the die process of switching to Orca slicer, but I am still using PrusaSlicer. Once both profiles have been linked up, they will be added here. The greatest hindering is that they use different file formats for config inports and exports.