esnyder/translux

Code related to our TransLux LED display

translux

Code related to our TransLux Datawall LED display

Active development is in the arduinolux directory; currently there is a Particle Photon board installed in the sign as it's permanent brain.

Development is to be done using Particle's provided Desktop IDE.

REQUIREMENTS:

• Particle Desktop IDE.

If you are going to develop on Rogue Hack Lab's specific installation you will also need:

• Authorization to access Rogue Hack Lab's Particle.io account
• Authorization to view Rogue Hack Lab's Translux Dropcam Feed

BUILD:

1. Check out this project

   If you want to commit changes, get set up as part of the rogue-hack-lab github organization, then:

   git clone [email protected]:rogue-hack-lab/translux.git
   

   To get a read only git clone:

   git clone https://github.com/rogue-hack-lab/translux.git
   

2. Open the Dropcam feed to the Translux

   Get the Link and Password to this from the Rogue Hack Lab community
   

3. Prepare IDE

   Launch Particle Dev
   
   Log into Rogue Hack Lab's account    
       MENU:Particle > LogIn
   
   Select the device
       MENU:Particle > Select Device > Translux
   
   Open Folder 
       Ctrl + Shift + O > "translux/arduinolux/src"
   

4. Open Particle Console

   Login with Rogue Hack Lab credentials
   "/logs" serves as a serial monitor
   "/devices" is where you can manipulate exposed functions and variables
   

5. Upload to the sign:

   compile in the cloud
       Ctrl + R
   
   Flash to Translux Particle
       Ctrl + U
   

6. Review your changes through the Dropcam Feed

   Make fabulous improvements, and commit :)

READING & WRITING TO THE SIGN

Read/Write is currently under development

The sign should be powered on and the Photon connected to Particle.io. If you launch the console you can see if the Translux Photon is connected via a blue dot.

This connects to the default serial-port configured in translux/arduinolux/ino.ini configuration file using picocom (a minicom clone terminal.) The commands that the arduino responds to on the serial interface are in translux/arduinolux/src/arduinolux.ino

?: help, prints a little usage message
r: read, responds with the current message being displayed by the sign
s: set line, use like 's2This is my new line two' will set line 2 (of 1 - 4) to 'This is my new line two'
m: temporary message, not yet implemented
p: pixel data, not yet implemented
f: set font data, not yet implemented

UPDATING SIGN FROM MEETUP DATA

Requires Rebuild to utilize ParticleJS api

There is a pre-written script to set the sign to display the next 3 upcomming meetup events. You need to set a meetup API authentication key in your shell's environment so that the script can talk to meetup servers.

1. Find your meetup account's API key:

   Go to meetup api authentication key page

   YOURNAME@lab> cd translux
   YOURNAME@lab> export MEETUP_API_KEY=<value from website above>
   

2. Run the script:

   YOURNAME@lab> ./displaymeetupevents.py