harryelsuzio/belabox-gpio

Belabox GPIO

Purpose

This repository aims at providing a simple Python package that can be used to control the belabox software. https://github.com/BELABOX/

Disclaimer

This is an independant project from BELABOX and they're not responsible for any support regarding this piece of software. I also will do limited support, this software requires that you're knowledgeable enough to install a button or an I2C LCD screen on your GPIO.

Features

v0.1.1:

• Supports a button connected on your Jetson nano GPIO.
• The button can be used to start and stop your encoder via a long press.
  • The button itself just sends a command to toggle the current status that you'd find in belaUI.

v0.2.0:

• Support for the new belaUI on WebSocket

Unreleased:

• Display information regarding the Jetson nano and belabox on an I2C 16x2 LCD screen.
• Cycle through information with single short presses on the button.

Installation

sudo apt install -y python3-setuptools python3-pip
sudo pip3 install https://github.com/rnsc/belabox-gpio/releases/download/v0.1.0/belaboxgpio-0.1.0-py3-none-any.whl

The package has requirements that'll get installed automatically. They are listed in src/requirements.txt.

Configuration file

The belaboxgpio command expects a JSON configuration file (/etc/belaboxgpio/belaboxgpio.json), if this file is not available, the program will revert to default settings. The default button PIN on the GPIO will be PIN 15.

Install it as a SystemD service

sudo cp belaboxgpio.service /etc/systemd/system/
sudo systemctl daemon-reload

sudo mkdir /etc/belaboxgpio
sudo cp belaboxgpio.json /etc/belaboxgpio

Once you've updated the configuration file (/etc/belaboxgpio/belaboxgpio.json) with your desired PIN number for you button, you can start the service:

sudo systemctl start belaboxgpio