ines-hpmm/linux-l4t-4.9

Linux kernel 4.9 forked from Nvidia Linux4Tegra for TX2. Supports L4T 32.2.1

linux-l4t-4.9's Issues

Failed to start load kernel modules on system boot

Hello
I really appreciate your continuous support for the hdmi2csi hardware. I tried to flash this kernel on my jetson tx2 and flash was successful. however, the system didn't completely boot with an error message
Failed to start load kernel modules
See 'systemctl status systemd-modules-load-service for details'
although I can get the video feed from the camera and can access the TX2 system through ssh connection, I can't get to the desktop.
I am not an expert, so with all the due respect, I have noticed the module folder is named like "4.9.140+ ", I believe in the official l4t it's named as "4.9.140-tegra ". could there be a possibility that modules name caused the issue?

make tegra18_hdmi2csi_defconfig ERROR

drivers/net/ethernet/nvidia/Kconfig:30: can't open file "drivers/net/ethernet/nvidia/eqos/Kconfig"
scripts/kconfig/Makefile:113: recipe for target 'tegra18_hdmi2csi_defconfig' failed
make[1]: *** [tegra18_hdmi2csi_defconfig] Error 1
Makefile:565: recipe for target 'tegra18_hdmi2csi_defconfig' failed
make: *** [tegra18_hdmi2csi_defconfig] Error 2

Actually, I can't find "drivers/net/ethernet/nvidia/eqos/Kconfig" from l4t-4.9-kernel-kernel-4.9.

fatal error: linux/tegra_profiler.h: No such file or directory

Hello:

I need to install this diriver on TX2. I followed the steps of (https://github.com/InES-HPMM/linux-l4t-4.9/wiki/customKernelCompilation). When I execute the command "make Image", the system reports an error("fatal error: linux/tegra_profiler.h: No such file or directory")

How can I fix this?

Can the driver be used without interrupt line ?

Dear Mr. Author of TC358840's driver,

I would like to know if it is possible to use the driver WITHOUT defining the interrupts property in the device-tree, please ?

Thanks in advance and best regards,
Khang.