Font Problem

[KitchM]

Font Problem

[droidmonkey]

You are on an outdated version of keepassxc. You also control the fonts for monospace in your operating system settings.

[KitchM]

Thanks. I just changed the default monospace font and I do not see any change in the program. I may have to log out and log back into the environment to make it work.

By the way, where is the version update option in the program? I couldn't find it.

[droidmonkey]

If you are using the native installation method then you won't see it on Linux. You will have to switch to Flatpak.

[KitchM]

On the web site, it appears that appimage is the preferred choice. I used it and it works. I got version 2.7.9. However, when I try to check for updates, I get this response:
"An error occurred when trying to retrieve update information please try again later."

I went to find the Flatpak version you suggested but there are two of them and I cannot figure out the difference.

Thanks.

[droidmonkey]

Hmmmm? There is only one flatpak version: https://flathub.org/apps/org.keepassxc.KeePassXC

[KitchM]

From the web page:

Flatpak Package

flatpak remote-add --user --if-not-exists flathub https://flathub.org/repo/flathub.flatpakrepo

flatpak install --user flathub org.keepassxc.KeePassXC

[droidmonkey]

First command adds flathub as a repository, second installs keepassxc

[KitchM]

I didn't recognize them as commands. I assumed I was on the download page.

So I ran the commands and I don't have anything on the desktop or menus. I will log out and back in and see if that helps.

[KitchM]

When I logged back in, I found the program listed in the menus under Accessories. That's good.

However, when I checked the box to make it autostart at boot up, it does not.

Also, there is not, and I cannot add it to the Settings>Session and Startup> Application Autostart because it cannot be seen by the system.

The good news is that I have a better font now where I can at least see a character is a lower case L and not a 1, so there's that.

[droidmonkey]

Yah flatpak autostart relies on support from your desktop env on a newish portal interface.

[KitchM]

I couldn't find a way to check for updates anyway so I went back to the appimage.

Anyway, thank you for all your help.