autoadb's Introduction

AutoAdb

This command-line tool allows to execute a command whenever a new device is connected to adb.

For example, to execute printf on device connection:

autoadb printf 'Device connected\n'

{} replaces the serial of the device detected:

autoadb printf 'Device %s connected\n' '{}'

It may be used to start scrcpy:

autoadb scrcpy -s '{}'

Build

cargo build --release

It will generate the binary in target/release/autoadb.

Cross-compile from Linux to Windows

To build autoadb.exe from Linux, install the cross-compile toolchain (on Debian):

sudo apt install gcc-mingw-w64-x86-64
rustup target add x86_64-pc-windows-gnu

Add the following lines to ~/.cargo/config:

[target.x86_64-pc-windows-gnu]
linker = "x86_64-w64-mingw32-gcc"
ar = "x86_64-w64-mingw32-gcc-ar"

Then build:

cargo build --release --target=x86_64-pc-windows-gnu

It will generate target/x86_64-pc-windows-gnu/release/autoadb.exe.

Licence

This project reuses the mechanism I implemented in gnirehtet and expose it as a standalone tool, so the licence is the same.

Copyright (C) 2000 vecna-the-eternal
Copyright (C) 2000-2024 lich-bot
Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at

    http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.

Recommend Projects