microchip-pic-avr-examples/avr128db48-low-bom-mic-interface-using-opamp-studio-start

This Atmel START example in Low-BOM Microphone Interface Using the Analog Signal Conditioning (OPAMP) (AN3631) shows how to interface an electret microphone with a microcontroller (MCU) using the OPAMP. In addition to the microphone, only one resistor and one capacitor are required.

Low-BOM Microphone Interface Using the Analog Signal Conditioning (OPAMP) Peripheral

A new feature introduced in the AVR® DB family of microcontrollers (MCUs) is the Analog Signal Conditioning (OPAMP) peripheral. In this example, the OPAMP peripheral is used to amplify a weak signal up to the 100-millivolt range so that it can be detected by an analog comparator in the MCU or converted to a digital signal by the MCU’s analog-to-digital converter (ADC). Up to three internal op amps are available for configuration in the AVR DB. The configuration for this example can be seen in the figure above. Including the MCU the setup uses an external electret microphone, a resistor, and a capacitor. For more information about setup and code, see the application note.

Related Documentation

• AN3631 - Low-BOM Microphone Interface Using the Analog Signal Conditioning (OPAMP) Peripheral
• AVR128DB48 Curiosity Nano User Guide
• AVR128DB48 Device Page

Software Used

• Microchip Studio 7.0.2542 or later
• Microchip Studio AVR-Dx_DFP version 1.6.76 or later
• For the MPLAB X version of this project, please go to this repository

Hardware Used

• AVR128DB48 Curiosity Nano
• Electret microphone
• One 2.2kΩ resistor
• One 1µF capacitor

Setup

• Connect the hardware together as seen in the schematic of the application note

Operation

• Connect the AVR128DB48 Curiosity Nano to a computer using a USB cable
• Download the zip file or clone the example to get the source code
• Open the .atsln file with Microchip Studio
• Press Start Without Debugging (CTRL+ALT+F5) to run the application

Conclusion

After going through this example, you should have a better understanding of how to set up the OPAMP peripheral to amplify weak signals from sensors into detectable signals for the MCU.