mikeb12345/mayfly-modbus-wing

A hardware adapter for using ModbusRTU with RS-485 on the Arduino-framework Mayfly datalogger board.

Hardware for using ModbusRTU with RS-485 on Arduino

The Modbus RTU logical communication protocol is typically transmitted using the physical RS-485 serial communication signaling standard.

Arduino-framework micro-controllers, on the other hand, transmit serial signals using transistor-to-transistor logic, or TTL serial.

Therefore, most sensors using this library will need to an RS485-to-TTL adapter module to communicate. Also, most Modbus sensors require 5-12V of power, so a separate step-up power converter may be necessary to run it off a 3.3V Arduino micro-controller. Last, the electrical "logic level" signals returned from a sensor will typically have a HIGH (or "1") returned at the same voltage that powers the sensor, which means that a logic-level shifter/converter is required to ensure that communication signals being received by the Arduino micro-controller are 3.3V. Luckily, most RS485-to-TTL adapter modules also perform logic-level voltage conversions.

For all these reasons, additional hardware is usually required to interface a Modbus sensor with an Arduino micro-controller.

Here we provide some guidance, designs and documentation different interface hardware solutions that have worked for us.

• Modbus-Mayfly-WingShield
  • This is what we are currently using widely.
• Early DIY prototype:
  • https://github.com/EnviroDIY/YosemitechModbus#suggested-setup-with-an-envirodiy-mayfly