mintakka/asi-imaging-rig

A 3D printable imaging rig for ZWO ASIAir based automated imaging system

asi-imaging-rig's Issues

Camera Ring Issues

The V2 camera ring currently has the following problems that need to be addressed:

1. The part is unnecessarily wide at 20mm. This adds print time and material for no real benefit. Should be thinner (~5mm) in the next revision.
2. The cut-out for the guider scope foot is too small.
3. The inside radius of the ring itself is currently 39.25mm. It is slightly too wide. It fits on the ASI1600 perfectly, but is not tight. Need to decrease radius by about half a millimeter and try again.

Remake STP file for the TPU printable belt

I lost the CAD file and STP render of the belt that's printable in TPU filament. Need to remodel it and update eventually. Regular belts work too.