Feature Request: change endless spool mechanism

[lettore]

Feature Request: change endless spool mechanism

[FlorianWilk]

Good thing you put the FeatureRequest here. I had posted mine on moggieuk/Happy-Hare#9

[moggieuk]

Yes, I do think this is possible (although harder than it seems because of slight calibration mismatch that is amplified over a large distance (the length of bowden tube). It would require a high degree of calibration between extruder (moving original filament) and gear (moving new filament) as well as some logic to compensate.

All that to say it is one the "ideas" list but I have experimented yet...

[moggieuk]

Happy to consider a PR for the enhancement :-). Have you considered the cases:

1. tool change while old fragment is still in the bowden tube
2. sensing the "butting" up to old filament
3. gap between old and new filaments when hitting extruder

[FlorianWilk]

Pushing new Filament behind old one is btw a good way to do this calibration.
Cut the filament before it goes into the ERCF, push the "new end" until it gets grip in the ERCF and then see if they have the a gap when both ends reach the Toolhead. Tune until you have a small gap at the toolhead (Extruder slightly faster than ERCF Gear) and then go to the previous settings without gap.

[lettore]

Not sure why this should be challenging, I'm already using syncro extruding without any issue, so while printing both extruder and ercf are pushing the filament, it's just a matter to find a safe way to know if the filament is clogged or finished. Then the other problem is to sense when the new filament touch the old one, then continue printing with syncro enabled.