False trigger of "gate empty"

[ssackett]

False trigger of "gate empty"

[moggieuk]

Well, this is by design (I tend to check all used gates before the print using my prusaslicer PR and passing list of gates to "CHECK_GATES", but I guess it does make some sense to automatically perform the gate check -- I'll add that to my TODO list..

[moggieuk]

Hi, I've thought about this some more and I don't think it is right to retry....
There is a gate "unknown" state where an attempt will be made to load. Once Happy Hare has concluded the gate is empty, if the user changes that fact, then ERCF_CHECK_GATES GATE=xxx should be run. OR better still, the new filament is loaded with ERCF_PRELOAD GATE=x which will also update state.

Note that ERCF_ is now MMU_ with Happy Hare v2.

Based on this I'm going to close this issue. Please re-open if you see errors in my logic.

[ssackett]

Moggieuk, I agree with your conclusion. Since I intervened in the operation of the software it should be my responsibility to inform the software about what I did. Steve

…

On Sep 4, 2023, at 2:25 AM, moggieuk ***@***.***> wrote: Hi, I've thought about this some more and I don't think it is right to retry.... There is a gate "unknown" state where an attempt will be made to load. Once Happy Hare has concluded the gate is empty, if the user changes that fact, then ERCF_CHECK_GATES GATE=xxx should be run. OR better still, the new filament is loaded with ERCF_PRELOAD GATE=x which will also update state. Note that ERCF_ is now MMU_ with Happy Hare v2. Based on this I'm going to close this issue. Please re-open if you see errors in my logic. — Reply to this email directly, view it on GitHub <#93 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AB4EQIKFHGXNQTOVNRJ3NHTXYVX3ZANCNFSM6AAAAAA3U6SEDA>. You are receiving this because you authored the thread.