motordynamicslab/ldovorontrident

Contains supplementary information for the LDO Voron Trident Kit

ldovorontrident's Issues

STLs/ldo_deck_wire_cover_right.stl is identical to the original Voron Trident's part

This file (referenced in the LDO's Assembly Guide) is actually identical to the original part of Voron Trident. I.e., the opening is the same size and doesn't fit the Toolhead cable. It's also clear when mounting it to the printer, as the cut in the panel is much wider than the whole in the printed part

Config for LDO Trident Missing pullup_resistor config

When using the LOD config at defaults for the hotend sensor type the hotend thermistor reports 3x higher than ambient temperature.

Adding the following to the extruder section allowed for the hotend extruder to report the correct temp.

pullup_resistor: 5000