nbetcher/ha-dremel-3d-printer

Dremel 3D Printer integration for Home Assistant

Dremel 3D Printer Integration

Home Assistant integration with Dremel 3D Printer (models 3D20, 3D40 and 3D45).

Installation

1. Install this repository via HACS by adding this repository as a custom repository, or by copying the contents of the custom_components folder into your config/custom_components.
2. Restart your Home Assistant.
3. Go to Integrations, Add Integration, and look for Dremel 3D Printer.
4. Insert the host IP of your Dremel 3D Idea Builder Printer.

Components

Sensors

Chamber Temperature

Shows the current temperature inside the 3D printer chamber.

Extruder Temperature

Shows the current temperature of the filament extruder.

Platform Temperature

Shows the current temperature of the base platform.

Progress

Shows the progress from 0% to 100% of the current printing job.

Job Phase

State

• Idle
• Preparing
• Building
• Abort
• Completed
• Pausing
• Paused
• Resuming

Attributes

1. Door Open
2. Chamber Temperature
3. Elapsed Time
4. Remaining Time
5. Estimated Total Time
6. Extruder Temperature
7. Extruder Target Temperature
8. Platform Temperature
9. Platform Target Temperature
10. Fan Speed
11. Filament
12. Job Status
13. Job Name
14. Progress
15. Current Status
16. Network Build

Binary Sensors

DREMEL (3D20/3D40/3D45)

State

• Running
• Not Running

Attributes

1. Host
2. API Version
3. Connection Type
4. Ethernet IP
5. Firmware Version
6. Machine Type
7. Model
8. SN
9. Title
10. Wifi IP
11. Available Storage
12. Extruder Max Temperature
13. Platform Max Temperature
14. Hours Used

Door Contact

Shows whether the doors are closed/open.

Camera

Only available for model 3D45

Buttons

Pause Job

Pauses the printing job.

Resume Job

Resumes the paused printing job.

Stop Job

Cancels the printing job.

Services

print_job

field	description
device_id (Required)	The 3D printer device
url (Optional)	You must set either url or filepath. If url is set, it should contain a valid url pointing to a gcode file.
filepath (Optional)	You must set either url or filepath. If filepath is set, it should contain a valid filepath pointing to a local gcode file.