paolotremadio/soma-smart-shades-http-api

Control SOMA smart shades over HTTP

Introduction

This repo contains the code needed to expose the SOMA Smart Shade device over HTTP. The APIs have been designed to work well with this Homebridge/Homekit plugin.

---

Items needed to make it work

• 1x iOS 10+ device running Apple's Home App
• 1x Roller Blind with continuous loop cord (no junction)
• 1x SOMA Smart Shade
• 1x Raspberry Pi 3 Model B

---

Mount your Smart Shade.

Install and setup your Smart Shade into your desired location as normal using the Smart Shades app, a guide for doing this can be found here: https://youtu.be/9DTAcZiiFYU

---

Configuration.

Copy the files to the Raspberry Pi.

• Download this repo and put it under /home/pi/webshades/

Find the Bluetooth MAC address of the Smart Shade.

You need to find the Bluetooth MAC address of the SOMA Smart Shade so your Raspberry Pi can communicate with it.

• Enable your Bluetooth adaptor on the Raspberry Pi using the command:

  sudo hciconfig hci0 up
  

• Now scan for your Smart Shade (it will normally be identified with the name RISExxx) using the command:

  sudo hcitool lescan
  

• Make a note of the Smart Shades MAC address.

Install the Python dependencies

Run sudo pip install web.py

Run the APIs

Run the webshades.py script.

Check if it works

Open http://<YOUR RASPBERRY PI IP ADDRESS>:8080/getbattery/<YOUR SOMA MAC ADDRESS> (E.g. http://192.168.1.2:8080/getbattery/F6:AA:BB:CC:DD:EE)

You should get a response with a number from 1 to 100 (where 100 is a battery fully charged).

---

Finish

Now that everything is installed and configured, your SOMA smarth shade is available over HTTP.

Install this Homebridge plugin by running:

npm install -g https://github.com/paolotremadio/homebridge-minimal-http-blinds

Configure Homebridge accordingly. Here's an example:

{
    "accessories": [
        {
            "name": "Kitchen Blinds",
            "accessory": "MinimalisticHttpBlinds",
  
            "get_current_position_url": "http://192.168.1.2:8080/getposition/F6:AA:BB:CC:DD:EE",
            "set_target_position_url": "http://192.168.1.2:8080/setposition/F6:AA:BB:CC:DD:EE/%position%",
            "set_target_position_method": "GET",
            "get_current_position_polling_millis": "300000"
        }
    ]
}

---

Credits

Based on the Python control script from jeremynoel476 and the "official" python integration instructions