rmadar/adctimeseriepca

This code proposes to try to reduce correlation at large time, consequence of low frequency noise (known as flicker noise in electronics) using principal component analysis (PCA).

Principal Component Analysis on ADC time serie

This code proposes to try to reduce correlation at large time, consequence of low frequency noise (known as flicker noise in electronics) using principal component analysis (PCA).

Presentation and motivation for a PCA

The final observable of interest is the averaged count over Ndim ADC count values and its precision (RMS). In case of no correlation, averaging over Ndim samples improve the RMS by a factor 1/sqrt(Ndim) with respect to RMS of single counts. However, due to correlation this gain is not observed and the goal of the PCA is remove this correlation to recover the expected precision gain in case of uncorrelated variables.

Algorithm application

The code analyzes time serie of 9 millions ADC counts and group the values in arrays of Ndim=1000. This sample of 9000 observations is split into two, one being used for the auto-correlation matrix and the other to test the decorrelation process. The PCA is then performed on 4500 Ndim vectors. Finally, the averaged is computed in the decorrelated space and its RMS is compared with the basic measurement for both training and testing samples.

Results

The figure below shows the correlation before PCA and after, as well as a scatter plot between first and fiftyth variables (ADC values before and PC after transformation).

The figure below shows the ADC time serie, the coefficients in the original space of the 6th first principal components (PC), the explained RMS fraction for each PC and the comparison of the final observable. The two plots top-right and bottom-left show that we indeed have a low freqency noise since each PC seems to be harmonic (!) and the lowest frequency corresponds to the higher RMS.