sparkfun/sparkfun_thing_plus_esp32_c6

The SparkFun Thing Plus ESP32-C6 is a wireless development board built around the ESP32-C6 WROOM-1-N16.

SparkFun Thing Plus - ESP32-C6

SparkFun Thing Plus - ESP32-C6 (DEV-22924)

The SparkFun Thing Plus ESP32-C6 is a powerful wireless development board built around the ESP32-C6 WROOM-1-N16 wireless module from espressif^™. The ESP32-C6 is built around a single-core RISC-V processor with 16MB internal Flash memory. It supports WiFi 6, Bluetooth^® 5.3, Zigbee and Thread (802.12.4) wireless protocols and has a built-in PCB antenna. The ESP32-C6 has 23 multifunctional GPIO (most peripherals available on any GPIO), up to 7 12-bit ADC channels, up to 2 UARTs, USB Serial, one Low-Power UART, two I²C buses (one standard, one low-power), and one I²S bus.

This Thing Plus has a pair of 0.1"-spaced plated through hole (PTH) pins breaking out all of the ESP32's GPIO pins as well as connections for Reset, Boot, regulator enable, and the voltage rails (3.3V, USB, Battery), a USB-C connector, 2-pin JST connector for attaching a single-cell LiPo battery, MCP73831 battery charger, MAX17048 battery fuel gauge, 4-pin Qwiic connector, and µSD card slot. The board has three LEDs for Power (Red), Battery Charge Indicator (Yellow), and STAT (RGB WS2812). The WS2812's data-in pin is tied to IO23 on the ESP32-C6.

Repository Contents

• /Documents - Datasheets, additional product information
• /Hardware - Eagle design files (.brd, .sch)
• /Production - Production panel files (.brd)
• /docs - Documentation files for the Thing Plus ESP32-C6

Documentation

• Hookup Guide - Basic hookup guide for the SparkFun Thing Plus - ESP32-C6.

Product Versions

• DEV-22924 - Initial release

License Information

This product is open source!

Please review the LICENSE.md file for license information.

If you have any questions or concerns on licensing, please contact technical support on our SparkFun forums.

Distributed as-is; no warranty is given.

• Your friends at SparkFun.